+
  • iCOOP-triac Series 20220517A3.JPG

10W Constant Current LED Driver Triac 0-100%Flicker-free

Classification:

Wide Voltage Input:100VAC~240VAC 50/60HZ Output:10W Max₁48VDC Max Class 2 level,fully protective plastic housing ■Built-in active PFC function PF:0.9 C Short Circuit /Overload /Temperature Protection Suitable for indoor LED lighting application Phase Dim Depth-dim TECH Triac /ELV 0-100%100-240VAC Flicker-free IEEE 1789 Standard 10W CC Wide voltage /Multiple current 17-Speed output 100/150/200/250/300/350/400mA Phase Dim Depth-dim TECH 3 years warranty


Product Specification


Model No.

iCOOP-triad

Function

Dimming Method

Triac/ELV

Output

Output Voltage

48VDC   Max

 

Current Range

100mA   150mA   200   mA   250mA   300mA   350mA   400mA

 

Power Range

1W-10W

 

Depth-dim TECH

High frequency exemption level /No Flicker

 

Dimming   Range

0-100%

 

Current Accuracy

±5%

 

No-load output Voltage

50VDC

 

Ripple current

<3%

 

Channel

 

 

 

 

 

Input

Range Input Voltage

100-240VAC

 

Frequency

50/60HZ

 

Power Factor

≥0.95@230VAC (Full load)

 

Ffficiency

>85%@230VAC (Full load)

 

THD

230Vac@THD≤15%(Full load)

 

Input Current

115Vac≤0.2A/230Vac≤0.1A

 

Inrush Current

Cold start 3.6A/230Vac (test twidth=45us under 50%lpeak)

 

Protects

Short Circuit

Intelligent closed if short circuit /Auto Recover

 

Over Load

ntelligent closed output if current load≥120%/Auto Recover

 

Temperature

Intelligent closed output current if Housing temperature ≥85°C /Auto Recover

Others

Dimension(Lx     WxH)

135×30×20mm(L×W×H

 

Packing Weight

80g

Cautions 1.This product should be installed by qualified personnel.

2.This product is non waterproof,need to avoid sun and rain.In case of outdoor use,please ensure it is mounted in

a water proof enclosure

3.Good heat dissipation conditions extend product life.Please install the product in a well-ventilated environment. 4.Please make sure LED power supply output voltage,current is used to meet the product requirements.

5.Please ensure that adequate sized cable is used from the controller to the LED lights to carry the current.Please also ensure that the cable is secured tightly in the connector

6.Due to safety concerns,PVC or rubber cord of 0.75-1.5mm²is recommended for input and output terminal (excluding

signal terminals).Flat power cord is not suitable.Ensure all wire connections and polarities are correct before applying power to avoid any damages to the LED lights.

7.In case of malfunction,do not repair it yourself.

Key words:

10W Constant Current LED Driver Triac 0-100%Flicker-free

Previous Page

Next Page

Online Message

Dear customers, if you have any comments and suggestions on our products or services, please tell us in time, we will give you satisfaction as soon as possible